User Manual

Product Profile

Introduction

The DJI Mavic 2 Pro/Zoom features omnidirectional Vision Systems and Infrared Sensing Systems.

Effortlessly capture complex shots using signature DJI technologies such as Obstacle Sensing and

Intelligent Flight Modes like Hyperlapse, Point of Interest, ActiveTrack

2.0, TapFly, QuickShots,

and Advanced Pilot Assistance Systems (APAS).

The Mavic 2 Pro features a fully stabilized 3-axis gimbal with a 1" CMOS sensor camera (jointly

developed by DJI and Hasselblad) that shoots 4K video, 20-megapixel photos, and supports filters.

The Mavic 2 Zoom features a fully stabilized 3-axis gimbal camera that shoots 4K video, 12-

megapixel photos, supports 2x optical zoom, 24-48 mm lens, and supports filters.

The Mavic 2 Pro/Zoom uses the latest technology to increase stability and footage quality, reducing

the Mavic 2 Zoom angle vibration range to within ±0.005° and Mavic 2 Pro angle vibration range to

within ±0.01°.

Built into the remote controller is DJI’s long-range transmission technology OCUSYNC

2.0,

offering a maximum transmission range of 5 mi (8 km) and displaying video from the aircraft to DJI

GO 4 on your mobile device at up to 1080p. The remote controller works at both 2.4 GHz and 5.8

GHz, and it can select the best transmission channel automatically without any latency. The aircraft

and camera can easily be controlled using the onboard buttons. An onboard LCD screen gives real-

time aircraft data information, and the detachable control sticks make the remote controller easier to

store. The maximum run time is 2 hours and 15 minutes. The Mavic 2 Pro/Zoom boasts a maximum

flight speed of 44.7 mph (72 kph) and a maximum flight time of 31 minutes.

The major difference between the Mavic 2 Pro and Mavic 2 Zoom is the camera. The general

descriptions in this manual apply to both Mavic 2 Pro/Zoom.

Maximum flight time was tested in an environment with no wind while flying at a consistent 15.5 mph

(25 kph) and the maximum flight speed was tested at sea level altitude with no wind. These values are

for reference only.

The remote controller reaches its maximum transmission distance (FCC) in a wide-open area with

no electromagnetic interference at an altitude of about 400 ft (120 m). The maximum runtime was

tested in a laboratory environment. This value is for reference only.

5.8 GHz is not supported in some regions. Please observe the local laws and regulations.

Preparing the Mavic 2 Pro/Zoom

Preparing the Aircraft

All aircraft arms are folded before the aircraft is packaged at the factory. Follow the steps below to

unfold the aircraft.

1. Remove the gimbal cover from the camera.

2. Unfold the front arms, and then unfold the rear arms.