User's Manual
Table Of Contents
©
2018 DJI All Rights Reserved.
65
INSPIRE 2
SERIES User Manual
OR
Method 1 Method 2
Method 2: When the aircraft has landed, push and hold the left stick down. The motors will stop
after three seconds.
Please check that CSC is activated inside DJI GO 4 app, then the user can stop the
aircraft mid-air.
Stop the Motor Mid-ight
Pull the left stick to the bottom inside corners and press the RTH button at the same time.
Only stop
the motors mid-ight in emergency situations when doing so can reduce the risk of damage or
injury.
Flight Test
Takeoff/Landing Procedures
1. Place the aircraft in an open, at area with the battery level indicators facing towards you.
2. Turn on the remote controller and your mobile device, then turn on the Intelligent Flight Battery.
3. Launch the DJI GO 4 app and enter the Camera page.
4. Wait until the Aircraft Indicators blink green. This means the Home Point is recorded and it is now
safe to y. If they ash yellow, the Home Point has not been recorded.
5. Push the left stick up slowly to take off or use Auto Takeoff.
6. Shoot photos and videos using the DJI GO 4 app.
7. To land, hover over a level surface and gently pull down on the left stick to descend.
8. After landing, execute the CSC command or hold the left stick at its lowest position until the mo-
tors stop.
9. Turn off the Intelligent Flight Battery rst, then the Remote Controller.