User's Manual

©
2018 DJI All Rights Reserved.
33
INSPIRE 2 SERIES User Manual
2. Turn on the Charging Hub, then connect it to a computer using a Micro USB cable.
3. Run the rmware update program. Press the update button and wait for the process to nish.
4. The Charging Hub will automatically restart when the update has been successfully completed.
5. Repeat this process if the rmware update fails for any reason.
Powering ON/OFF
Powering On: Press the Power Button once, then press again and hold for 2 seconds to power on.
The Power LED will turn red and the Battery Level Indicators will display the current
battery level.
Powering Off: Press the Power Button once, then press again and hold for 2 seconds to power off.
Heating the Battery
Manual Heating: When the battery is powered off, press and hold the power button for 3 seconds to
manually initiate battery warmup.
The battery will warm up if the temperature is below 59℉ (15℃). As it warms, LED 1 & 2 and LED 3
& 4 will blink alternately. The battery will stop warming when it reaches 68℉ (20℃).
The temperature of the battery will be remain between 59-68℉ (15-20℃) when alternating LED 1
and LED 4 blinking indicates that it is above 59℉ (15℃). This will last for approximately 30 minutes
then it will power off automatically.
Auto Heating: Insert the batteries into the aircraft and power on. When the temperature of the
battery is below 59℉ (15℃), it will warm up automatically. Check the LEDs for the current power
level.
Using the Battery