User's Manual

Table Of Contents

INSPIRE 2 SERIES

User Manual

Remote Controller Diagram

[1] Power Button

Used to turn the Remote Controller on and

off.

[2] Transformation Switch

Toggle the switch up or down to raise or

lower the landing gear during ight.

[3] Return-to-Home (RTH) Button

Press and hold the button to initiate Return

to Home (RTH).

[4] Control Sticks

Controls the orientation and movement of

the aircraft.

[5] Status LED

Displays the Remote Controller's system

status.

[6] Battery Level LEDs

Displays the battery level of the Remote

Controller.

[7] Power Port

Connect to the Charger to charge the battery

of the remote controller.

[8] Mobile Device Holder

Securely mounts your mobile device to the

remote controller.

[9] Antennas

Relays aircraft control and video signal.

[10] Handle Bar

[11] Control Dial (Gimbal/FPV)

Use this dial to control gimbal tilt. In the gimbal Free Mode, pressing and holding the C1 Button

and rotating the control dial adjusts gimbal pan. To adjust the tilt of the FPV camera, press and

hold the C2 Button and rotate the control dial.

[12] Camera Settings Dial

Turn the dial to adjust camera settings. (Only functions when the remote controller is connected

to a mobile device running the DJI GO 4 app.)

[13] Record Button

Press to start recording video. Press again to stop recording.

[14] Flight Mode Switch

Switch between P-mode, S-mode, and A-mode.

17 18 19

1615

2221