User's Manual

14
©
2018 DJI All Rights Reserved.
INSPIRE 2 SERIES User Manual
Atti Mode Warning
The aircraft will enter A-mode in the following two instances:
Passive: When there is weak GPS signal or when the compass experiences interference where the
Vision System is unavailable.
Active: Users toggle the ight mode switch to A-mode.
In A-mode, the Vision System and some advanced features are disabled. Therefore, the aircraft
cannot position or auto-brake in this mode and is easily affected by its surroundings, which may
result in horizontal shifting. Use the remote controller to position the aircraft.
Maneuvering the aircraft in A-mode can be difcult. Before switching the aircraft into A-mode, make
sure you are comfortable ying in this mode. DO NOT y the aircraft too far away as you might lose
control and cause a potential hazard.
Avoid ying in areas where GPS signal is weak, or in conned spaces. The aircraft will otherwise be
forced to enter A-mode, leading to potential ight hazards, please land it in a safe place as soon as
possible.
Flight Status Indicator
The Inspire 2 comes with the Front LED, Rear LED and Aircraft Status Indicator. The positions of
these LEDs are shown in the gure below:
The Front LEDs show the orientation of the aircraft. Front and rear LEDs can be turned off in the
DJI GO 4 app. The Aircraft Status Indicator communicates the system status of the ight controller.
Refer to the table below for more information about the Aircraft Status Indicator.
Aircraft Status Indicator Description
Normal
Red, yellow, green, blue and purple ashes Turning On and Self Diagnostic Testing
×4 Four yellow ashes Warming Up
Slow green ashing P-mode with GPS*
×2 Two green ashes
P-mode with Forward and Downward
Vision Systems*
Slow yellow ashing
No GPS and Forward and Downward
Vision Systems
Fast green ashing Braking
Rear LEDFront LED
Aircraft Status Indicator