Avata Charging Hub User Guide v1.0

1 2 3
Battery Ports Status LED Power Port (USB-C)
电池接口 状态指示灯 电源接口（USB-C）
電池連接埠 状态指示灯 電源連接埠（USB-C）
배터리 포트 상태 LED 전원 포트 (USB-C)
Akkuschacht Status-LED Stromanschluss (USB-C)
Puertos para
las baterías
Led de
estado
Puerto de alimentación
(USB-C)
Ports de
batterie
LED d'état
Port d'alimentation
(USB-C)
Vani batterie LED di stato
Porta di alimentazione
(USB-C)
Accupoorten Statusled Voedingspoort (USB-C)
Entradas da
bateria
LED de
status
Entrada de alimentação
(USB-C)
Disclaimer
Carefully read this entire document and all safety and
compliance guidelines provided before use.
Warnings
1. When using the charging hub to charge the Intelligent
Flight Batteries, it is recommended to use the DJI 65W
Portable Charger or a USB Power Delivery charger.
2. The charging hub is only compatible with the BWX169-
2420-14.76 Intelligent Flight Battery. DO NOT use the
charging hub with other battery models.
3. Placethecharginghubonaatandsturdysurfacewhen
in use. Make sure the device is properly insulated to
preventrehazards.
4. DO NOT cover the battery or charging hub when
charging. Otherwise, heat dissipation will be affected.
5. DO NOT touch the metal terminals on the charging hub.
6. If there is any noticeable buildup on the metal terminals,
clean with a dry cloth.
Usage
When used with a compatible charger, the DJI AVATA
TM
Battery Charging Hub can charge up to four Intelligent Flight
Batteries in sequence from a high to low power level.
1. As shown in the figure, insert the battery into the battery
port on the charging hub and connect the charging hub
toapoweroutlet (100-240V,50/60Hz)usingacompatible
charger.Thegureusesthe DJI65WPortableChargeras
an example.
EN
1
1 2 3