Avata - Safety Guidelines v1.0
Compliance Information
FCC Compliance Notice
Supplier’s Declaration of Conformity
Product name: DJI Avata
Model Number: QF2W4K
Responsible Party: DJI Technology, Inc.
Responsible Party Address: 201 S. Victory Blvd., Burbank, CA 91502
Website: www.dji.com
We, DJI Technology, Inc., being the responsible party, declares that the
above mentioned model was tested to demonstrate complying with all
applicable FCC rules and regulations.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party
responsibleforcompliancecould voidtheuser’sauthoritytooperate
the equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turningtheequipmentoandon,theuserisencouragedtotrytocorrect
the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connecttheequipmentinto anoutletonacircuitdierentfromthat
to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. In order to avoid the possibility of
exceeding the FCC radio frequency exposure limits, human proximity to
the antenna shall not be less than 20cm during normal operation. This
transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
ISED Compliance Notice
This device contains licence-exempt transmitter(s)/receiver(s) that comply
withInnovation,ScienceandEconomicDevelopmentCanada’slicence-
exempt RSS(s). Operation is subject to the following two conditions: (1)
This device may not cause interference.(2)This device must accept any
interference, including interference that may cause undesired operation
of the device.
L’émetteur/récepteurexemptdelicencecontenudansleprésentappareil
estconformeauxCNRd’Innovation,SciencesetDéveloppement