Matrice 30 Series - User Manual
Table Of Contents
- Using This Manual
- Product Profile
- Flight Safety
- Aircraft
- Remote Controller
- Starting and Activating the Remote Controller
- Remote Controller Overview
- Mounting the WB37 Intelligent Battery
- Mounting the Dongle
- Mounting the Strap and Bracket Kit
- Adjusting the Antennas
- IP Rating
- User Interface
- Video Transmission
- Remote Controller LEDs and Alert
- Charging the Remote Controller and Checking the Battery Level
- Linking the Remote Controller and Control Stick Modes
- Buttons Overview
- Flight Mode Switch (N/S/F)
- Calibrating the Compass
- HDMI Settings
- Advanced Dual Operator Mode
- Intelligent Battery Station
- Intelligent Flight Battery
- DJI Pilot 2 App
- Firmware Update
- Appendix
92
©
2022 DJI All Rights Reserved.
MATRICE 30 SERIES User Manual
c. When the compass of the remote controller is working normally, the blue dot shows the
direction of the remote controller. If the signal is poor during ight, point the arrow of the
remote controller in Navigation Display to the direction of the aircraft.
6. Home Point Distance: displays the horizontal distance between the Home Point and the aircraft.
7. PinPoint Information: displays the name of the PinPoint and the horizontal distance from the aircraft
to the PinPoint, when PinPoint is enabled.
8. Waypoint Information: displays the name of the waypoint, the horizontal distance from the aircraft to
the waypoint, and the ascending or descending trajectory of the ight route, during a mission ight.
9. RNG Target Point Information: displays the horizontal distance from the aircraft to the target point,
when the RNG laser rangender is enabled.
10. Vertical Obstacle Sensing Information: Once an obstacle is detected in the vertical direction, an
obstacle bar icon will appear. When the aircraft reaches the warning distance, the icon will glow
red and orange, and the remote controller will emit long beeping sounds. When the aircraft reaches
the obstacle braking distance, the icon will glow red, and the remote controller will emit short beep
sounds. Both the obstacle braking distance and the warning distance can be set in DJI Pilot 2.
Follow the prompted instructions in the app to set them.
Horizontal Obstacle Sensing Information: The light areas are the obstacle sensing areas of the
aircraft, while the dark areas are the blind spots. During ights, keep the aircraft speed vector line
out of the obstacle-sensing blind spots.
a. If the warning distance set in the app is from 16 m to 33 m, once an obstacle is detected, a
green arc will appear in the direction of the obstacle; when the obstacle reaches the warning
distance, it turns orange; when the obstacle approaches the obstacle breaking distance, it
changes to a red frame.