Matrice 30 Series - User Manual
Table Of Contents
- Using This Manual
- Product Profile
- Flight Safety
- Aircraft
- Remote Controller
- Starting and Activating the Remote Controller
- Remote Controller Overview
- Mounting the WB37 Intelligent Battery
- Mounting the Dongle
- Mounting the Strap and Bracket Kit
- Adjusting the Antennas
- IP Rating
- User Interface
- Video Transmission
- Remote Controller LEDs and Alert
- Charging the Remote Controller and Checking the Battery Level
- Linking the Remote Controller and Control Stick Modes
- Buttons Overview
- Flight Mode Switch (N/S/F)
- Calibrating the Compass
- HDMI Settings
- Advanced Dual Operator Mode
- Intelligent Battery Station
- Intelligent Flight Battery
- DJI Pilot 2 App
- Firmware Update
- Appendix
53
©
2022 DJI All Rights Reserved.
MATRICE 30 SERIES User Manual
Mounting the WB37 Intelligent Battery
A WB37 battery (excluded) can be mounted onto the remote controller in the following steps.
1
2
3
1. Push the rear cover release button to the end to open the rear cover.
2. Insert the WB37 battery into the battery compartment and push it to the top. There will be a clicking
sound to indicate the battery is installed rmly.
3. Close the rear cover.
To remove the WB37 battery, press and hold the battery release button and push the battery
downward.
Mounting the Dongle
The USB-C connector in the dongle compartment can be used to connect a USB-C dongle (excluded)
in the following steps.
1. Push the rear cover release button to the end to open the rear cover. Remove the screws to open
the dongle compartment.
2. Insert the dongle into the USB-C connector. Close the dongle compartment.
3. Attach the dongle compartment with the screws. Close the rear cover.
2
1
3
6
7
4
5