Matrice 30 Series - User Manual
Table Of Contents
- Using This Manual
- Product Profile
- Flight Safety
- Aircraft
- Remote Controller
- Starting and Activating the Remote Controller
- Remote Controller Overview
- Mounting the WB37 Intelligent Battery
- Mounting the Dongle
- Mounting the Strap and Bracket Kit
- Adjusting the Antennas
- IP Rating
- User Interface
- Video Transmission
- Remote Controller LEDs and Alert
- Charging the Remote Controller and Checking the Battery Level
- Linking the Remote Controller and Control Stick Modes
- Buttons Overview
- Flight Mode Switch (N/S/F)
- Calibrating the Compass
- HDMI Settings
- Advanced Dual Operator Mode
- Intelligent Battery Station
- Intelligent Flight Battery
- DJI Pilot 2 App
- Firmware Update
- Appendix
46
©
2022 DJI All Rights Reserved.
MATRICE 30 SERIES User Manual
Custom Network RTK
To use Custom Network RTK, make sure that the remote controller has a Wi-Fi connection. Custom
Network RTK can be used to replace the D-RTK 2 Mobile Station. Connect the Custom Network RTK
account to the designated NTRIP server to send and receive dierential data. Keep the remote controller
turned on and connected to the internet when using this function.
1. Make sure that the remote controller is connected to the aircraft and the internet.
2. Go to the camera view in the DJI Pilot 2 app, tap and then select . Select “Custom Network
RTK” as the RTK service type and ll in the required information. Then tap “Save”.
3. Wait to connect to the NTRIP server. In the RTK settings, when the status of the aircraft’s positioning
in the status table shows “FIX”, it indicates that the aircraft has obtained and used dierential data
from Custom Network RTK.
IP Rating
1. Under stable laboratory conditions, the M30/M30T achieves an IP55 protection rating by IEC
60529 standards when equipped with TB30 Intelligent Flight Batteries. The protection rating is not
permanent, however, and may reduce over an extended period.
a. DO NOT y when the amount of rainfall exceeds 100 mm in 24 hours.
b. DO NOT fold the frame arms in the rain. Make sure the aircraft is free of any liquid by wiping
it carefully before storing in the carrying case.
c. Make sure the battery ports, battery compartment ports, battery surfaces, and battery
compartment surfaces are dry before inserting the batteries.
d. Make sure the ports and surfaces of the battery are free from any liquid before charging.
e. The product warranty does not cover water damage.
2. The aircraft does not achieve IP55 protection rating in the following circumstances:
a. Frame arms are folded.
b. Batteries other than the M30/M30T TB30 Intelligent Flight Batteries are used.
c. The cover for the ports are not attached correctly.
d. The waterproong top shell plug is not rmly attached to the top shell.
e. The aircraft is broken in situations such as where the aircraft shell is cracked or the
waterproof adhesive is not secure.
3. The aircraft body uses ame retardant materials to improve safety performance, which may lead the
color of the appearance to be changed. Such change does not aect the performance and the IP
rating of the aircraft.