Matrice 30 Series - User Manual
Table Of Contents
- Using This Manual
- Product Profile
- Flight Safety
- Aircraft
- Remote Controller
- Starting and Activating the Remote Controller
- Remote Controller Overview
- Mounting the WB37 Intelligent Battery
- Mounting the Dongle
- Mounting the Strap and Bracket Kit
- Adjusting the Antennas
- IP Rating
- User Interface
- Video Transmission
- Remote Controller LEDs and Alert
- Charging the Remote Controller and Checking the Battery Level
- Linking the Remote Controller and Control Stick Modes
- Buttons Overview
- Flight Mode Switch (N/S/F)
- Calibrating the Compass
- HDMI Settings
- Advanced Dual Operator Mode
- Intelligent Battery Station
- Intelligent Flight Battery
- DJI Pilot 2 App
- Firmware Update
- Appendix
118
©
2022 DJI All Rights Reserved.
MATRICE 30 SERIES User Manual
Using DJI Assistant 2 (Enterprise Series)
DJI Assistant 2 (Enterprise Series) supports the updating of the remote controller and aircraft but not the
BS30 battery station. Please use the DJI Pilot 2 app to update the battery station.
Aircraft and Remote Controller
1. Connect the remote controller or aircraft to the PC one by one, as the assistant software does not
support the updating of multiple DJI devices at the same time.
2. Make sure the PC is connected to the internet and the DJI device is powered on with a battery level
higher than 25%.
3. Run the assistant software, log in with your DJI account and enter the main interface.
4. Tap the rmware update button on the left side of the main interface.
5. Select the rmware version and tap to update. The assistant software will download and update the
rmware automatically.
6. When the "Update successful" prompt appears, the device update is completed, and the DJI device
will restart automatically.
The battery rmware is included in the aircraft rmware. Be sure to update the rmware of all
batteries.
For the rmware update process, the battery levels of the aircraft and remote controller must
be higher than 25%.
Make sure all DJI devices are connected properly to the PC during an update.
During the update process, it is normal for the gimbal to go limp, the aircraft status indicators
to blink, and the aircraft to reboot. Wait patiently for the update to complete.
Make sure to keep the aircraft away from people and animals during a firmware update,
system calibration or parameter conguration.
For safety, make sure you are using the latest rmware version.
After the rmware update is completed, the remote controller and the aircraft may become
disconnected. Re-link them if necessary.
During a rmware update, DO NOT insert or remove the batteries to avoid battery update
failure.
During a rmware update, DO NOT unplug the USB-C cable to avoid rmware update failure.
Oine Update
An oine rmware package can be downloaded from the DJI ocial website to an external storage
device such as a microSD card or U disk. Run DJI Pilot 2, tap HMS, and then Firmware Update. Tap
Oine Update to select the rmware package of the remote controller, aircraft, or battery station from
the external storage device and tap Update All to update.