Matrice 30 Series Known Issue List

Matrice 30 Series Known Issue List
http://www.dji.com/matrice-30
Copyright © 2022 All Rights Reserved 1
Date:
2022.04.29
Aircraft Firmware:
v04.01.00.00
Remote Controller Firmware:
v01.02.01.24
DJI Pilot 2 App Android:
v4.0.1.13
D-RTK 2 Mobile Station:
v03.01.0000 (incl. Matrice version)
Intelligent Battery Station:
v04.01.00.00*
Intelligent Flight Battery:
v02.00.20.34
DJI Assistant 2 (Enterprise Series):
v2.1.3
Firmware Upgrade Method:
Aircraft / Remote Controller: DJI Assistant 2 / App
D-RTK 2 Mobile Station: DJI Assistant 2
The built-in DJI Pilot 2 app: will be updated with the Remote
Controller firmware
Intelligent Battery Station: App (Connect the Battery Station to the
remote controller and update it on the HMS page in the DJI Pilot 2
app.)
* The Intelligent Battery Station firmware update includes the battery update. After being updated, the battery
station version will be shown as v05.02.12.29 in DJI Pilot 2.
Known Issues in v04.01.00.00
The issues below will be optimized or solved in the later versions.
Module
Issue Description
Workaround Solution
Flight
Controller
System
The aircraft may sense obstacles by mistake in snowy
weather, resulting in the aircraft not being able to fly
when operating with the control sticks.
It is recommended to disable the obstacle sensing for
emergency operations. Make sure to manually control
the aircraft with the remote controller and watch the
camera view to avoid potential safety hazards during
the flight.
Remote
Controller
The remote controller will not unmute by pressing
the combination buttons after turning on Mute
through the shortcut panel.
Turn off Mute on the shortcut panel to enable the
sound.
Video
Transmission
When using the Advanced Dual Operator mode for
pipeline inspections, after the aircraft and Controller
A are disconnected, Controller B may not take full
control of the aircraft.
Power off Controller A or restart Controller B and
reconnect to the aircraft. The issue will be solved in
later versions.
Battery
Station
In Standard mode, when inserting a fully charged
TB30 battery, the battery station may occasionally
stop charging the other batteries.
Check and remove any fully charged batteries.