User's Manual
Table Of Contents
- Using This Manual
- Product Profile
- Aircraft
- Flight Modes
- Aircraft LEDs and Status Indicator
- Return to Home
- Vision Systems and Infrared Sensing Systems
- Advanced Pilot Assistance Systems (Only Mavic 2 Enterprise is supported)
- Flight Recorder
- Password Protection
- Attaching and Detaching the Propellers
- Intelligent Flight Battery
- Gimbal and Camera
- DJI AirSense
- Modular Accessories
- Remote Controller
- DJI Pilot App
- Flight
- Appendix
Mavic 2 Enterprise Series User Manual
©
2019 DJI All Rights Reserved.
7
Preparing the Aircraft
All aircraft arms are folded before the aircraft is packaged at the factory. Follow the steps below to
unfold the aircraft.
1. Remove the gimbal cover from the camera.
2. Unfold the front arms, and then unfold the rear arms.
1
2
3
3. Attaching the propellers.
Attach the propellers marked white to the motors with white marks. Press the propeller down onto
the motors and turn until it is secure. Attach the other propellers to the unmarked motors. Unfold all
the propeller blades.
*Attach the gimbal cover when not in use.
1
)
Hold the gimbal in place and insert gimbal clamp between the aircraft and the gimbal.
2) Make sure the hooks on the Gimbal Protector are locked in the grooves of the aircraft, then lower
the Gimbal Protector over the gimbal and secure with the buckle. The buckle will click when it is
securely attached.
Grooves Hooks
Gimbal clamp