User Manual

MATRICE 200

SERIES V2 User Manual

Mounting the Gimbal and Camera

Make sure to press down the gimbal detachment button when rotating the gimbal lock to

remove the gimbal and camera. The gimbal lock should be fully rotated when removing the

gimbal for the next installation.

Mounting the Intelligent Flight Batteries

Insert a pair of batteries.

Press once to check the battery level.

Press again and hold until the batteries turn on or off.

Press the Gimbal

Detachment button

to remove the cover.

Align the white

and red dots and

insert the gimbal.

Rotate the gimbal

lock to the locked

position.

Only use battery slot B when using one battery to supply power. In this case, the aircraft

can only be powered on, but cannot take off.

If for any reason only one battery is available during ight, land the aircraft immediately

and replace the batteries as soon as possible. In this case, the gimbal connectors and

the ports at rear of the aircraft cannot supply power to their connected devices.

Make sure to use the included TB55 batteries. DO NOT use any other type of batteries.

Removing the Intelligent Flight Battery

Make sure to press the battery removal button when removing the battery.

Gimbal Connector II Gimbal Connector I

Zenmuse XT Zenmuse X4S/X5S/X7/XT2/Z30

Zenmuse Z30 Zenmuse X4S/X5S/X7/XT/XT2

2 3

Low

High