User Manual

46
©
2019 DJI All Rights Reserved.
MATRICE 200 SERIES V2 User Manual
Linking the Remote Controller
The remote controller comes linked to your aircraft before delivery. Linking is only required when
using for the remote controller for the rst time. Follow these steps to link a remote controller:
1. Power on the remote controller, connect to your mobile device, and launch DJI Pilot.
2. Power on the Intelligent Flight Battery.
3. Enter the Camera View >
, and tap the Linking Remote Controller button.
4. The DJI Pilot app will display a countdown box, the remote controller will be ready to link, with its
display showing Connecting and a beeping sound being emitted.
5. Locate the Linking button on the aircraft and press the Linking button to start linking. The remote
controller display shows the current status information.
Restart the remote controller and try again if the remote controller display shows No
Connection indicating that linking failed.
Fully charge the remote controller before each ight.
If the remote controller is powered on and is NOT in use for five minutes, an alert will
sound. After 6 minutes, it will automatically power off. Move the sticks to cancel the alert.
Ensure the antennas of the remote controller are unfolded and adjusted to the proper
position to achieve optimal transmission quality.
Repair or replace the remote controller if damaged. A damaged remote controller antenna
greatly decreases performance.
Fully charge the battery at least once every three months to maintain battery health.
Press the C1 and C2 buttons and the Start/Stop button for fast linking.
Ensure the r emote controller is within 1.6 ft (0.5 m) of the air craft during linking.
The remote controller will unlink itself from an aircraft if a new remote controller links to the
same aircraft.
In Dual Remote Controller Mode, the Assistant remote controller must also be relinked to
the aircraft when the Primary remote controller is relinked to the aircraft.