Owner's Manual
Table Of Contents
- User Manual
- Using This Manual
- Product Profile
- Aircraft
- Flight Modes
- Aircraft LEDs and Status Indicator
- Return to Home
- Vision Systems and Infrared Sensing Systems
- Advanced Pilot Assistance Systems (Only Mavic 2 Enterprise is supported)
- Flight Recorder
- Password Protection
- Attaching and Detaching the Propellers
- Intelligent Flight Battery
- Gimbal and Camera
- DJI AirSense
- Modular Accessories
- Remote Controller
- DJI Pilot App
- Flight
- Appendix
- In the Box
- Quick Start Guide
- Mavic 2 Enterprise Series Release Notes
- Intelligent Flight Battery Safety Guidelines
- Disclaimer & Safety Guidelines
- Warranty Period of Main Parts
Mavic 2 Enterprise Series User Manual
©
2019 DJI All Rights Reserved.
65
Calibration Procedure
Choose an open area to carry out the following procedure.
1. Tap the System Status Bar in DJI Pilot, select “Calibrate”, and follow the on-screen instructions.
2. Hold the aircraft horizontally and rotate it 360 degrees. The Aircraft Status Indicator will turn solid
green.
3. Hold the aircraft vertically, with its nose pointing downward, and rotate it 360 degrees around a
vertical axis.
4. If the Aircraft Status Indicator blinks red, the calibration has failed. Change your location and try the
calibration procedure again.
Horizontal Calibration
Vertical Calibration
The aircraft can take off immediately once calibration is complete. If you wait more than three
minutes to take off after calibration, you may need to calibrate again. It is possible that another
compass interference warning will appear while the aircraft is on the ground. This indicates
that the current location is not suitable for flying the aircraft, due to the level of magnetic
interference.
Firmware Updates
Use DJI Pilot or DJI Assistant 2 for Mavic to update the aircraft rmware.
Using DJI Pil
ot
When you connect the aircraft or remote controller to DJI Pilot, you will be notied if a new rmware
update is available. To start updating, connect your mobile device to the internet and follow the on-
screen instructions. Note that you cannot update the rmware if the remote controller is not linked to the
aircraft.
Using DJI Assistant
2 for Mavic
The USB-C port is used when connecting the aircraft to a computer to update rmware.
Follow the instructions below to update the rmware through DJI Assistant 2 for Mavic: