Manualshelf

User Manual

ManualsBrandsDJI ManualsOtherDJI Inspire 2 Quadcopter with CinemaDNG and Apple ProRes Licenses
61626364656667686970
62
©
2017 DJI All Rights Reserved.
INSPIRE 2
User Manual
If the Aircraft Status Indicator blinks red and yellow after the calibration procedure, move
your aircraft to a different location and try again.
DO NOT calibrate the compass near metal objects such as a metal bridge, cars,
scaffolding.
If the aircraft status indicators are blinking red and yellow alternately after placing the aircraft
on the ground, the compass has detected magnetic interference. Change your location.
Auto Take-off and Auto Landing
Auto Takeoff
Use auto takeoff only if the Aircraft Status Indicators are blinking green. Follow the steps below to
use the auto takeoff feature:
1. Launch the DJI GO 4 app, and enter “Camera” page.
2. Complete all steps on the pre-ight checklist.
3. Tap“
”, and conrm that conditions are safe for ight. Slide the icon to conrm and takeoff.
4. Aircraft takes off and hovers at (1.2 meters) above ground.
Aircraft Status Indicator blinks rapidly when it is using the Vision System for stabilization.
The aircraft will automatically hover below 10 meters. It is recommended to wait until there
is sufcient GPS lock before using the Auto Take-off feature.
Auto-Landing
Use auto-landing only if the Aircraft Status Indicator is blinking green. Follow the steps below to use
the auto-landing feature:
1. Tap on
, to ensure the landing condition is ideal. Slide to conrm.
2. Abort landing process immediately by using the
button on the screen.
3. a. When Landing Protection determines that the ground is suitable for landing, the Inspire 2 will
land gently.
b. If Landing Protection determines that the ground is not suitable for landing, the Inspire 2 will
hover and wait for pilot conrmation.
c. If Landing Protection is not operational, the DJI GO 4 app will display a landing prompt when
the Inspire 2 descends below 0.7 meters. Pull down on the throttle or use the auto landing
slider to land.
4. Aircraft will land and turn off automatically.
Starting/Stopping the Motors
Starting Motors
A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the bottom in-
ner or outer corners to start the motors. Once the motors have started spinning, release both sticks
simultaneously.
OR