User Manual-inspire 2

ManualsBrandsDJI ManualsCamcordersInspire 2 Quadcopter with CinemaDNG and Apple ProRes Licenses

INSPIRE 2

User Manual

GPS Signal Strong Blinking Green

Zone Restriction DJI GO 4 app Prompt

Aircraft

Status

Indicator

No-y Zone

Motors will not start.

Warning: You are in a No-fly

zone. Take off prohibited.

Red ashing

If the aircraft enters the

restricted area in A-mode,

but is switched to P-mode,

the aircraft will automatically

descend, land, and stop its

motors.

Warning: You are in a no-y

zone. Automatic landing has

begun.

Restricted-

altitude ight

zone

If the aircraft enters the

restricted area in A-mode, but

is switched to P-mode, it will

descend to an appropriate

altitude and hover 15 feet

below the altitude limit.

R1: Warning: You are in a

restricted zone. Descending to

safe altitude.

R2: Warning: You are in a

restricted zone. Maximum ight

altitude is restricted to between

20m and 500m. Fly cautiously.

Warning zone

No flight restriction applies,

but there will be a warning .

Warning: You are approaching

a restricted zone, Fly cautiously.

Free zone

No restrictions. None. None.

Semi-automatic descent: All stick commands are available except the left stick command

during the descent and landing process. Motors will stop automatically after landing.

When flying in a safety zone, the aircraft's status indicator will blink red rapidly and

continue for 3 seconds, then switch to indicate current ying status and continue for 5

seconds at which point it will switch back to blinking red.

For safety reasons, please do not y close to airports, highways, railway stations, railway

lines, city centers, or other sensitive areas. Fly the aircraft only within your line of sight.

PreightChecklist

1. Remote controller, Intelligent Flight Battery, and mobile device are fully charged.

2. Propellers are mounted correctly and rmly.

3. Micro SD card has been inserted, if necessary.

4. Gimbal is functioning normally.

5. Motors can start and are functioning normally.

6. The DJI GO 4 app is successfully connected to the aircraft.

7. Ensure that the sensors for the Obstacle Sensing System are clean.