User Manual

INSPIRE 2

User Manual

GPS Signal Strong Blinking Green

Zone Restriction Aircraft Status Indicator

No-y Zone

Motors will not start.

Red ashing

If the aircraft enters the restricted area in A-mode,

but is switched to P-mode, the aircraft will

automatically descend, land, and stop its motors.

Restricted-

altitude ight

zone

If the aircraft enters the restricted area in A-mode,

but is switched to P-mode, it will descend to an

appropriate altitude and hover 15 feet below the

altitude limit.

Warning zone

No flight restriction applies, but there will be a

warning .

Free zone

No restrictions. None.

Semi-automatic descent: All stick commands are available except the left stick command

during the descent and landing process. Motors will stop automatically after landing.

When flying in a safety zone, the aircraft's status indicator will blink red rapidly and

continue for 3 seconds, then switch to indicate current ying status and continue for 5

seconds at which point it will switch back to blinking red.

For safety reasons, please do not y close to airports, highways, railway stations, railway

lines, city centers, or other sensitive areas. Fly the aircraft only within your line of sight.

PreightChecklist

1. Remote controller, Intelligent Flight Battery, and mobile device are fully charged.

2. Propellers are mounted correctly and rmly.

3. Micro SD card has been inserted, if necessary.

4. Gimbal is functioning normally.

5. Motors can start and are functioning normally.

6. The DJI GO 4 app is successfully connected to the aircraft.

7. Ensure that the sensors for the Obstacle Sensing System are clean.