User Manual
20
©
2017 DJI All Rights Reserved.
INSPIRE 2
User Manual
The aircraft automatically adjusts its speed when it senses an obstacle in front, or if it ies too close to the
ground. The DJI GO 4 app will show a prompt if the aircraft ies over an obstacle or to the left or right of
the obstacle. However, this feature should not be relied upon for navigation between obstacles. Failsafe
procedures will override TapFly. If the GPS signal weakens, the aircraft will exit autonomous ight and
return to home.
12
R
09:29
AE
P-GPS
AF/ MF
ISO
SHUT TER
EV
200 0.3
F
5.61/200
CAPA CIT Y
4KP3020:12 384G
SD TIME
4KP30
74%
70%
4.07V
4.07V
H 10.0MD 30M
VS 2.0M/S VPS 2.0MH.S 10.0 M/S
In Flight (GPS)
5000K
WB
Custom
DO NOT guide the aircraft to y towards people, animals, small and ne objects (e.g. tree
branches and power lines) or transparent objects (e.g. glass or water).
Watch for the obstacles in the ight path and stay clear of them.
There may be deviations between the expected and the actual ight path of TapFly selection.
The selectable range for the target direction is limited. You cannot make a TapFly selection
close to the upper or lower edge of the screen.
TapFly Mode may not work properly when the aircraft is ying over water or snow covered areas.
Be extra cautions when ying in dark (< 300 lux ) or bright (>10,000 lux) environments.
Enable control stick control of the gimbal inside the DJI GO 4 app to control gimbal
orientation using the remote controller. When control sticks are in use, the gimbal will
automatically change into Free Mode. In this situation, the control stick used to control pitch
on the aircraft now controls gimbal pitch, and the control stick used to control aircraft roll
now controls gimbal pan. The left dial now controls ight speed.
After conrming the TapFly selection, the aircraft will y in the direction marked by the icon. Note that you
can still use the control stick to control the movement of the aircraft during the ight.
Exit TapFly
Use the following methods to exit TapFly:
1. Tap “ ” button on the screen.
2. Pull back the pitch stick on the remote controller and hold for more than 3s.
3. Press the Intelligent Flight Pause button on the remote controller.
30M
30M