User Manual

©
2017 DJI All Rights Reserved.
17
INSPIRE 2
User Manual
Critical Low
battery level
warning
The aircraft
must land
immediately.
Aircraft status
indicator blinks
RED quickly.
The DJI GO 4 app display
will ash red and the aircraft
will start to descend. The
remote controller will sound
an alarm.
Allow the aircraft
to descend
and land
automatically.
Estimated
remaining
ight time
Estimated
remaining ight
based on current
battery level.
N/A N/A N/A
When the Critical low battery level warning is triggered and the aircraft begins to land
automatically, push the left stick upward to make the aircraft hover at its current altitude,
giving you an opportunity to navigate to a more appropriate landing location.
The colored zones and markers on the battery level indicator bar reect the estimated
remaining ight time. They are automatically adjusted according to the aircraft’s current
location and status.
Failsafe Safety Notices
20米
20米
H
The aircraft cannot avoid obstruction during the Failsafe RTH when
the Forward Vision System is disabled. Therefore, it is important to set
a suitable Failsafe altitude before each ight. Launch the DJI GO 4
app, enter Camera and tap to set the Failsafe Altitude.
20 m
20 m
H
If the aircraft is ying under 65 feet (20 meters) and Failsafe (including
Smart RTH, Lower Battery RTH ) is triggered, the aircraft will first
automatically ascend to 65 feet (20 meters) from the current altitude.
You can only cancel the ascending by exiting the Failsafe.
20 m
20 m
H
Aircraft automatically descends and lands if RTH is triggered when
the aircraft ies within a 65 feet (20 meters) radius of the Home Point.
Aircraft will stop ascending and immediately return to the Home Point
if you move the left stick if the aircraft reaches 65 feet (20 meters)
altitudes or beyond during Failsafe.
Aircraft cannot return to the Home Point when GPS signal is weak
( [
] displays less than four bars) or unavailable.
20米
20米
H
if you move the left stick after the aircraft rises above 65 feet (20
meters) but below the pre-set Failsafe RTH altitude, the aircraft will
stop ascending and immediately return to the Home Point.