User Manual

Installation

DJI Lightbridge 2 User Manual

Below is an illustration using the USB video output. Please prepare a slotted screwdriver.

Install the Mobile Device Holder:

1. Unfold the Mobile Device Holder . Remove the screw using the slotted screwdriver .

2. Plug the Mobile Device Holder into the Ground System and tighten the Screw Lock.

3. Line up the hole on the Mobile Device Holder with the metal loop on the Ground System.

Insert and tighten the screw.

Mount Your Display Device:

1. Press the button on the side of the Mobile Device Holder to release the clamp.

2. Place your mobile device inside the clamp and adjust it to secure.

3. Connect your mobile device to the remote controller via a USB cable.

4. Adjust the antennas to the desired position.

Mounting Hole

Screw Lock

Metal Loop

The SDI or HDMI cable can be attached to the Ground System handle using the Wire

Clip (optional accessory).

The SDI and HDMI ports on the Ground System cannot be used together.

USB – Mount your mobile device onto the Mobile Device Holder and connect it to the Ground

System using a USB cable. Launch the DJI GO app to access video and ight telemetry.