Avata - User Manual v1.0

64
© 2022 DJI All Rights Reserved.
Maintenance
Aircraft
Follow the steps below to replace components of the aircraft such as the propeller guard, or upper frame.
It is recommended to remove the propellers and Intelligent Flight Battery before replacing the propeller
guard and upper frame.
Propeller Guard
Detaching
1. Flip the aircraft over, remove the two screws as shown in the figure below, then gently remove the vision
module and disconnect the FPC connector. DO NOT over-extend the cable to avoid irreversible damage.
1
2
2. Remove the four screws on the landing gears, then remove the antenna covers. Pull the tab to remove the
antenna board, then remove the antenna cables along the cable groove.