Manual

DJI Osmo Action 4

User Manual

• Press down on the camera until the clips of the quick-release adapter mount are

rmly inserted into the quick-release slots on the camera, and then tighten the locking

screws. Press both clips of the quick-release adapter mount when removing the

camera.

• Osmo Action Curved Adhesive Base can only be applied to clean curved surfaces once.

DO NOT attach the curved adhesive base to surfaces that are at, rough, powdered,

peeling, covered in dust or sand, or have oil, wax, or water stains. Otherwise, the

adapter mount may not be attached rmly.

• The recommended application temperature for the base is -10° to 40° C (14° to 104° F).

DO NOT attach the adhesive base to a surface with a higher or lower temperature.

Osmo Action Horizontal-Vertical Protective Frame

With the Osmo Action Horizontal-Vertical Protective Frame, users can ip the camera from the

horizontal to the vertical position for dierent shooting angles. As shown in the gure below,

open the buckle of the horizontal-vertical protective frame, align and place the camera into the

frame, and then close the buckle. The left side of the frame is equipped with two quick-release

slots, which can be used with the Osmo Action Quick-Release Adapter Mount to fasten other

accessories such as the Osmo Action Curved Adhesive Base Kit and the Osmo 1.5m Extension

Rod.

90°90°