Instruction manual

28
Rear-Facing Use: 5-35 lbs. (2.3-16 kg), 19-36” (48-91 cm)
4
6
7
5
Push LATCH hook
through the rear-facing
belt path slot.
Pull other end of LATCH
hook between buckle
strap and rear harness
slot.
Push LATCH hook
through the other rear-
facing belt path slot.
Put seat pad back over
corners of shell.
Completed threading of
the LATCH system rear-
facing is shown.
Rear-Facing Installation with
LATCH: Install in Vehicle
2
3
Fasten one LATCH belt
hook to the anchor in
the vehicle seat located
in the vehicle seat bight.
Repeat for other side of
child restraint. See your
vehicle owner’s manual
for more information.
Push down firmly on the
child restraint and pull up
on the loop to tighten
belt.
L
E
V
E
L
T
O
G
R
O
U
N
D
Place child restraint rear-
facing in the back seat.
With child restraint in
the most reclined
position, make sure level
lines on shoulder belt
positioning guide are
level with ground. Adjust
child restraint if needed.
NOTE: Tuck top
anchorage strap and
hook under the base.
1
29
continued on next page.
4358-5356 US All in One 7/26/10 4:16 PM Page 31