Instruction manual

24
25
A loose top anchorage (tether) strap can
result in serious injury or death.
A loose LATCH system can result in
serious injury or death.
After deciding whether to use your Vehicle Belts or
LATCH, be sure to read the warnings below as they
pertain to both systems.
Rear-Facing Installation
When LATCH is not
available, fasten belt hooks
together behind the child
restraint as shown.
NOTE: Do not use the
top anchorage strap
(tether) in the rear-facing
position.The top
anchorage strap and hook
should be placed under
the child restraint.
WARNING:
!
Rear-Facing Use: 5-35 lbs. (2.3-16 kg), 19-36” (48-91 cm)
3
Rear-Facing Installation with
Vehicle Belt:
Thread the vehicle lap or
lap/shoulder belt
combination through the
rear-facing belt slot.
Thread UNDER seat pad
between buckle strap and
rear slots and out
opposite side. Buckle
vehicle belt.
Do not place vehicle
belt over child’s legs.
2
L
E
V
E
L
T
O
G
R
O
U
N
D
Place child restraint rear-
facing in the back seat.
With child restraint in
the most reclined
position, make sure level
lines on shoulder belt
positioning guide are level
with ground. Adjust child
restraint if needed.
NOTE: Tuck top
anchorage strap and
hook under the base.
1
continued on next page.
4358-5356 US All in One 7/26/10 4:16 PM Page 27