User manual

5 / 7
4. Operating
4.1. Preparation
1. When you made sure that there are no damages and all pieces are included put the machine
on a plane surface.
2. Open the lid of the fluid tank and fill in the required fluid. Make sure that you use only fluids
which are recommended by B&K. Other fluids can cause a not required effect or damage the
machine.
3. Close the lid and make sure that there are liquids run into the machine. Liquids in machines
can cause a short circuit and are danger to life and limb.
4.2. Start-up
1. Connect the power cable (included in delivery) with a power connector with the right technical
dates for the machine. Make sure that there is a ground connection.
2. Put the control in the dedicated plug.
3. The machine needs 4,5min to heat up. Now you can push the green Fog button on the control
and the machine starts. The button is momentary, which means that the fog machine will only
output while button is pressed.
4.2.1. Wireless Controller
With the wireless control you may control up to 4 independent fog machines or many more if you run
them simultaneously.
1. Put the wires receiver into the fog machine 5-pin port labeled “Wireless Controller”.