Instruction manual

XWEB 3000 – rel.1.7–
92/136 1592010600
The counter signals shows the status of the data you are
downloading.
Beware that it may happen you cannot succeeded in displaying all the data values you are interested
in. In this situation XWEB 3000 will alert you with this window:
This usually happens whenever the time period is too long. You can also use the “Min. data interval”
value. By default it is set to 5 minutes. Increasing this period you can decrease the amount of data that
will be lost. If you push “Continue”, the system will build a graph using only a partial amount of data. In
the example above the 37 percent of data will not be showed. In any case the lost portion is the oldest
one. If you push “Change parameters”, XWEB 3000 stops the displaying procedure and you are
brought back in the main graphs page.
As soon as the loading procedure ends, you will see something like this:
• Zoom in/out procedures
Before executing the zoom it is necessary, if there is more than a graph displayed, to select the
desired graph.
Click, with the left button of the mouse, into the top bar of the information of graph itself.
To zoom in you just have to keep pressed to left mouse button.
To zoom out you just have to keep pressed to right mouse button
• Zoom into an area