Instruction manual

XWEB 3000 – rel.1.7–
72/136 1592010600
The parameter table is defined by this columns:
Label:
The parameter label as described into the instruction manual of the instrument itself;
Description:
Description of the parameter function;
Actual:
Actual value of the parameter loaded from the instrument;
New:
New value of the parameter decided by the user;
Min /Max:
Minimum and maximum limits available for that parameter;
UM:
Unit of measurement;
Pr:
Parameter level of the parameter itself;
Save:
Selection box to enable the parameter saving.
• To change a parameter value
To insert the desired value of a parameter click into New box.
Depending on the kind of parameter, it is possible to insert the value or select it from a drop-down
list of available values.
To confirm the new value introduced click the mouse outside the “New” box area.
It is not allowed to set a value exceeding the minimum and maximum limits. In any case a wrong
value is signalled with violet background colour of the box itself.
The user can change one or more parameters before sending back the new list.
• To change the programming level
Select 1 level or 2 level under the Pr column.
• To send the new parameter map to the instrument
After modifying the parameters, select “Write on Device” from the “Action” menu.
To confirm the operation click on the Ok button into the message box.
• To send the new parameter map to the instruments
The displayed parameter map can be sent to many compatible devices.
Select “Write on Devices” from the “Action” menu.
The message box will show all the compatible instruments with that map.
Select which instruments are included (or “All”).
Click on the “Write” button to start the procedure.
A warning box will appear reminding you how many parameters you are changing.
Each writing operation is described into the message box.
At the end of the operation a conclusive report will be showed.
• To save the parameter in your Client PC