Instruction manual

XWEB 3000 – rel.1.7–
1592010600 Pag. 59 / 136
3.3.5.5 DEFINE THE DIGITAL, ANALOGUE INPUTS AND THE STATUS
The lower area is dedicated to the analogue inputs (probe), digital inputs, digital outputs and
status assignments.
NAME: The first time each name is displayed by following the internal XWEB 3000 archive of
standard feature of the instruments. Each definition can be renamed when necessary to give the
proper meaning. Beware of the difference between integer and decimal value. Instruments are
factory preset to decimal point, so if you change this value to integer you need to make the same
change inside XWEB 3000. All default labels are intended as decimal, when you change to integer
a postfix “-I” is shown. It may happen that you move to integer using advanced properties (see
Appendix A), then coming back to label name and changing it without using “-I” you completely
loose the information you are displaying integer. This may be a problem because when you come
back to advanced section there is no more difference between decimal and integer.
Udm: The analogue input is followed by the proper unit of measurement, change the unit by
clicking in it then insert the new value. Beware that in this window you can change only the label of
the unit of measurement. In Advanced section you can change the behaviour of the instrument
(e.g. Celsius or Fahrenheit degree)
Read: when enabled the value is computed and displayed.
Save: when enabled the value is logged.
Click “Confirm” now or at the end of the whole configuration.
• Delete one device from the list
From Selection find the instrument to delete.
Click on “Cancel”.
• Advanced function
The “Advanced” key allows to reach another configuration area dedicated to the instrument setup.
This area is very dangerous because this configuration defines important features that can badly
affect the result if not properly set.