Instruction manual

XWEB 3000 – rel.1.7–
1592010600 Pag. 37 / 136
3.3.2.3 RTC SYNCHRONIZATION
In this section user can
decide how often to
synchronise the
controller equipped with
a real time clock.
Interval is expressed in
hh:mm. The maximum
value accepted is 12:00.
It means that every 12
hours a synchronise-
command is sent to the
controller. To enable a
controller, the user has to
go to the “Devices” page
and check the “RTC
Synchr.” checkbox.
3.3.2.4 DEFROST COMMANDS
In this section you can
set-up a group of defrost
categories, then using
“time” label you can
decide different “Time
Band” events to start a
defrost. Remember time
format is 24h.
Eg: To the “Frozen food
defrost” category can
correspond the defrost
interval 07:00, 13:30,
20:00, 00:30.
With the new software release 3.0 it is possible to use the Scheduler (see §46 Scheduler) to send
commands. We strongly suggest to migrate to this new tool due to the fact that using a defrost
command via category the controller does not stop its own defrosts time table. On the contrary as long
as the defrost command is sent via Scheduler the controller stops its own defrost time table. After 20
minutes without communication between XWEB 3000 and the controller, the latter will start its own
defrost time table.
• To insert a new item
Click into the field “Name” and insert the word or the words that more represents the application
Only one “Default” can be selected for this category;
Click “Insert” do include the new item into the list. Wait the screen refresh.
• To modify an existing item
Select the item from the “Selection” list;
Change the “Name” description;
Click the “ Default ” if necessary;
Click on “Modify”. Wait the screen refresh.
• To delete one of the item of the list
Select the item from the “Selection” list;
Click on “Cancel”;
Confirm the operation if necessary. Wait the screen refresh.