Instruction manual

XWEB 3000 – rel.1.7–
1592010600 Pag. 33 / 136
To synchronise XWEB 3000 real time clock with the value of an atomic clock available on internet,
click on Synchro button:
• The XWEB 3000 must reaches the remote time server. To allow this check your network
configuration or setup a dial-up connection to internet. Ask your network administrator.
3.2.4 SERVER PROPERTY
• Operative System Version Linux version
• Resources Level of used memory
• IP adr Address of the server
• CPU temp Internal temperature to use as a diagnostic value.
• Readout RS485 activity
• Recording Recording activity
• Alarm transmission Transmission status
• Average cycle time Time to complete the instrument reading
• Remote connection Connection status
• Last connection Time and date of the last connection
It is important that CPU temperature does not overheat above 77°C (170°F). When this happens the
temperature value is displayed in red colour. Please check the correct fan functioning and the
environment temperature, if XWEB 3000 usually has an overheat CPU. Standard environmental
values must be between 0°C (32°F) and 40°C (104°F).
3.2.5 ALARMS
This area immediately shows the system or the instrument active alarms detected during the
connection.
The alarm list is repetitively updated in short time intervals.
To manually force the alarm updating: click on the “No alarm ..”
3.3 CONFIGURATION MENU
In this menu you can find all the web pages that allow the final user to interact with the XWEB 3000
system setup. Moreover the user can properly setup controllers’ behaviour, start/stop acquisition,
etc…
3.3.1 DEVICE FIND OF THE INSTRUMENTS CONNECTED TO THE “RS485”
SERIAL LINE
The unit is capable to find the Dixell instruments connected to the RS485 serial line.
Before starting the procedure be sure that all the devices are properly connected to the RS485 line
and the corresponding addresses are properly set.
Be sure that all the instruments are properly supplied.
Be sure of the number of the instruments you are going to find to avoid losing time in counting.
To start the procedure, first select from the Configuration roll down menu the item “Stop Recording”
then “Device Find”.