Instruction manual

XWEB 3000 – rel.1.7–
14/136 1592010600
Press confirm (see APPENDIX: ADVANCED SECTION) and setup the new model by ticking the
options you need.
e) If you must add more than 1 controller, you can use the clone function. Go to device, then press
“Clone”. The function starts, a pop-up appears, press “cancel”. This function will assign the model you
have just setup to all the others that are present in the setup.
WARNING
: this procedure, if the user makes a mistake, overwrites the existing model of the selected
devices with a new model that is NOT compatible.
2.1.7 LOCAL CONNECTIVITY
2.1.7.1 LOCAL CONNECTION WITH MONITOR, MOUSE AND KEYBOARD
On the back side, the XWEB 3000 is provided with the sockets for a monitor, a mouse and a
keyboard. Please connect all the peripherals before powering-on the unit otherwise the system may
fails to recognise them. This means that , for example, if you do not plug the monitor cable now, you
won’t see anything displayed on it.
The unit can also work without these three elements therefore if the user intend to work just with the
remote, he can definitively remove them after the setup operations.
In any case inside XWEB 3000 is loaded a standard browser to allow the user setting up the unit.
If necessary check the instructions manual of each device connected to the unit.
The operative procedure to work with XWEB 3000 is the same for all connection method.
2.1.7.2 LOCAL CONNECTION THROUGH PERSONAL COMPUTER
It is possible to use the local connection with a single PC, provided with LAN card, by using the net
connector RJ 45 (LAN). Due to the PC-client power, this kind of connection is more suitable for the
setup procedures. Remember that the PC must be provided with internal or external LAN card
adapter.
IMPORTANT: the cable between the Server and the PC must be with crossing wires (“Bridge
Cable”).The connection procedure from the remote PC is made simply by launching the Browser
program and inserting the default address of the XWEB 3000 unit http://192.168.0.200. Proper
information about setting up a network connection for the client PC, can be found inside the
INSTALLATION MANUAL on §4.1.