Instruction manual

XWEB 3000 – rel.1.3–
2.2.1 SYSTEM CONFIGURATION
The on/off switch is on the back of the unit.
Press the bottom of the switch (marked with I ) to turn the server on, immediately
the led marked with Power turns on.
For few minutes the Server starts loading the operative system, the local monitor
shows the loading messages of each system while the HDD led (hard disk) is
blinking.
After the first loading of the operative system, you are required to setup the unit by using a Wizard
program. This wizard will appear only during the very first power-on of the unit.
Before proceeding please notice that in the right side of the fields that you will see during setup
procedure there is a question mark. By clicking on it a pop-up windows with a contextual help will
appear.
The first windows ask you to choose your language and keyboard layout:
2.2.1.1 KEYBOARD
2.2.1.2 SYSTEM IDENTIFICATION
Now choose a proper name for the unit. You can use two data fields: “System name” and “System
description”. We strongly suggest that you always use the same criteria. This will help you to manage
more than one XWEB. It is possible to load a custom log in the Home-Page. Supported file format are:
JPG, GIF e PNG. The logo file is: 600 pixels width per 50 pixel high. Maximum file size is 150KB.
2.2.1.3 DATE/TIME
Next windows ask you to adjust real time clock of the unit, moreover you have to choose your correct
time zone. There are 25 integer World Time Zones from -12 through 0 (GMT) to +12. Each one is 15°
of Longitude as measured East and West from the Prime Meridian of the World at Greenwich,
England. Some countries have adopted non-standard time zones, usually 30 minutes offset.
Each Time Zone is measured relative to Greenwich, England. By setting the right Time Zone the
system will be able to calculate the local time independently on the Client calling Country.
16/111 1592010600