Installation manual

1592010880 XWEB3000_5000 EVO OPR GB r1.0 2014.11.28 80/100
3.5.2.5 SENDING COMMANDS TO THE DEVICE
Commands can be manually sent to the selected device, such as "Device OFF", "Device ON", "Active
Defrost", etc., via the "Single view" window. To send the command, press the button as demonstrated below:
Confirmation will be requested after which the user is informed whether or not the command was
successfully sent.
3.5.2.6 VARIABLE SECTION FOR REAL TIME GRAPH
The graph in the "single view" desktop is a "real time" graph which, by default, shows the "Pb1" variable of
the device. The display interval is that of the last three hours.
In this section the user may also wish to view other variables: to add/remove them from the graph, select the
variables from the "device view" section during the full view phase.
The graph can be scrolled with the "flag" cursor using your mouse: the "flag" provides the exact value of the
variables on the graph itself.