Installation manual

1592010880 XWEB3000_5000 EVO OPR GB r1.0 2014.11.28 33/100
- List of alarms for User
- Full configuration
3.3.7 STOP/START ACQUISITION
The XWEB-EVO principally identifies two mutually exclusive statuses:
1. Acquisitions stopped. This status allows for the configuration of the basic machine parameters. For
example, it provides the user with the necessary access to configure parameters relative to the
system or to the controller network configuration. This status does not allow for monitoring or
supervision. Therefore, the controller alarms cannot be detected and notified.
2. Acquisitions active. This status enables the configured machine to establish constant communication
with the instrument network and, consequently, allows for monitoring and supervision. Attention: this
status must be enabled at the end of the machine's configuration by the installer.
The status of the acquisitions is displayed on the navigation bar, so it can be identified by the user on each
XWEB-EVO page.
Acquisitions active:
Acquisitions inactive:
Access MENUACQUISITIONSStart Acquisition to start the acquisitions