Installation guide

XWEB SERIES Installation Guide
04/11/2004 1592017000 Pg. 23/74
5 Modem connection (“or point to point
connection”)
It represents the most common method where the LAN (intranet /
Ethernet / internet) is not available.
It is strongly advised to use a dedicated telephone line.
IMPORTANT: Use exclusively modem devices approved by
Dixell.
Remember that many modems are not compatible with Linux.
The list of compatible models can be found under the menu:
Configuration – System - Modem.
USB Modem (recommended).
Connect the USB Modem to the USB Port on the back side using
the modem cable commonly included into the modem packaging
itself. There is no need to give power supply to the modem because
the Server provides it through the USB port.
The modem reset is directly controlled by the XWEB 3000 Server
through the USB port by turning off and then on the modem device.
Connect the modem to the telephone line with the phone cable
included into the modem packaging. Remember to check if there is
a switching machine.
The connection procedure is divided in two parts. In the first part it is
necessary to create the Remote Access, in your PC, set with the
telephone number of the line where the XWEB 3000 is connected
to. You have to use Dixell as Username and Password.
The second is the procedure you will ever use: after launching the
new Remote Access that will engage the line through the modem,
start the Browser from your PC and insert the address
http://192.168.1.200 into Explorer/Netscape address bar.