Installation guide

XWEB SERIES Installation Guide
04/11/2004 1592017000 Pg. 11/74
It is possible to connect to the unit via a single PC provided with
LAN card, by using the net connector RJ 45 (LAN). Due to the PC-
client power, this kind of connection is more suitable for the setup
procedures.
IMPORTANT: the cable between the Server and the PC must be
with crossing wires (“Bridge Cable”).
The connection procedure from the remote PC is describe in deep
in this guide. You may need some changes to your PC network
card, then you will be able to connect to XWEB 3000 via Ethernet
line. Once you have finished setting up your network card,
connection to XWEB 3000 is established simply by launching the
Browser and inserting the default IP number of the unit
http://192.168.0.200 into the address bar.
Before going on reading, please take some moments to write down
your PC network setup, may be we are going to change it. If the IP
address of your PC belong to the hierarchy 192.168.0.XYZ (where
XYZ represent a number between 1 and 254), you can reach XWEB
3000 simply plugging in the network cable.