Instruction manual

XWEB 500 – rel.1.0 –
By clicking on “Test” XWEB 500 starts sending data packet to the selected controller. Depending on the
number of sent back packet the percentage is shown in 3 different colours: red (bad connection), yellow
(average connection) and green (good connection). This tool is useful to discover problem on the RS 485
wiring.
3.9.3 SERVER STATUS
Click on “Tools” -> “Server Status”. This window gives you important information about the XWEB 500
status. If there is some errors, they will be displayed in this section. The user can access this window also
from the home page. The label “Server Status” show you the current status. If there is an error a small icon
will appear. By clicking on it a report windows will appear.
Server without errors Server with errors
3.9.4 MESSAGE STATUS
click on “Tools” -> “Message status”. This windows show you the status queue of all messages that have to
be sent by XWEB 500. If the server did not succeed in sending a message, an error is shown.
10/01/2006- 1592010900 Pag. 87 / 103