Instruction manual

XWEB 500 – rel.1.0 –
NAME: The first time each name is displayed by following the internal XWEB 500 archive of standard
feature of the instruments. Each definition can be renamed when necessary to give the proper meaning.
Beware of the difference between integer and decimal value. Instruments are factory preset to decimal
point, so if you change this value to integer you need to make the same change inside XWEB 500. All
default labels are intended as decimal, when you change to integer a postfix “-I” is shown. It may happen
that you move to integer using advanced properties (see Appendix A), then coming back to label name
and changing it without using “-I” you completely loose the information you are displaying integer. This
may be a problem because when you come back to advanced section there is no more difference
between decimal and integer.
To change a name simply click inside its field and modify it.
Unit: The analogue input is followed by the proper unit of measurement, change the unit by clicking in it
then insert the new value. Beware that in this window you can change only the label of the unit of
measurement. In Advanced section you can change the behaviour of the instrument (e.g. Celsius or
Fahrenheit degree)
Click “Confirm” now or at the end of the whole configuration.
• Delete one device from the list
Stop acquisitions. Select the instrument to delete.
Click on “Cancel” in “Action” menu.
• Advanced function
The “Advanced” key allows to reach another configuration area dedicated to the instrument setup.
This area is very dangerous because this configuration defines important features that can badly affect
the unit if not properly set.
Take care of this advice and ask authorised personnel before trying any kind of setting.
You can find more complete information in Appendix A.
3.3.6.6 CLONE FUNCTION
This function is intended to let the user save a lot of time during the first setup of the XWEB 500.
By using this function the system will broadcast the current instrument setup to all the other that are
compatible. The compatible instruments are only the ones who belong to the same model. In this
situation the user is requested to made only one setup, then using “clone” button in few seconds
(depending on the total number of instruments) the configuration will be applied to all the other
controllers.
In the first step you are required to make a complete setup regarding both standard and advanced
section.
When you are ready, please go to “Configuration” -> “Devices” roll-down menu. This window will appear:
10/01/2006- 1592010900 Pag. 51 / 103