Instruction manual

XWEB 500 – rel.1.0
•Server Status OK, or a warning icon will be displayed
3.2.4 ALARMS
This area immediately on the right hand side shows the currently active alarms of the instrument.
The alarm list is repetitively updated in a short time interval.
To manually force the alarm updating: click on the “Active Alarms”
3.3 CONTROLLERS SETUP
3.3.1 DEVICE FIND OF THE INSTRUMENTS CONNECTED TO THE “RS485” SERIAL
LINE
The unit is capable to find the Dixell instruments connected to the RS485 serial line. Before starting the
procedure be sure that all the devices are properly connected to the RS485 line and the corresponding
addresses are properly set. Be sure that all the instruments are properly supplied. Be sure of the number of
the instruments you are going to find to avoid losing time in counting them later. To start the procedure, first
click on “Data recording” and uncheck all values, push modify. Click on “Configuration -> “Device find” roll-
down menu. A new page loads.
Adjust the address range and push “Start”. During the RS485 polling Tx/Rx led blinks and this windows will
appear:
When the search is complete a new window will appear.
To use the new controllers, under “Operation” column check the box “Insert”, then push “Add”.
3.3.2 CATEGORIES
28/103 10/01/2006 - 1592010900