Technical data

Ichill 200CX EVO rev 1.1 14/11/2013
Pag. 35 of 151
7 Proportional output for modulating compressor 2
8 Condenser fan circuit 1
9 Condenser fan circuit 2
After selection number 9 it is possible to configure the analog output as digital output with the same meaning
of the relays configuration; every analog output can be configured from “o 1” to “c50” (see relay
configuration table).
Proportional output configuration OUT 3 and OUT 4 (0 ÷ 10 Vdc / 4..20Ma / PWM)
0 Not enabled
1 Modulated evaporator water pump
2 Modulated Free cooling valve
3 not used
4 Auxiliary output 0÷10V n° 1
5 Auxiliary output 0÷10V n° 2
6 Proportional output for modulating compressor 1
7 Proportional output for modulating compressor 2
8 Condenser fan circuit 1
9 Condenser fan circuit 2
10 Condenser fan circuit 1
11 Condenser fan circuit 2
After selection number 11 it is possible to configure the analog output as digital output with the same
meaning of the relays configuration; every analog output can be configured from “o 1” to “c50” (see relay
configuration table).
12. PROBE SELECTION FOR REGULATION WITH SELECTABLE PROBE
For some regulators it is possible to select the reference probe; in this case select the probe as showed
below:
1= Pb1 of Ichill
2= Pb2 of Ichill
3= Pb3 of Ichill
4= Pb4 of Ichill
5= Pb5 of Ichill
6= Pb6 of Ichill
7= probe mounted in remote keyboard 1 (VICX620)
8= probe mounted in remote keyboard 2 (VICX620)
9= Pb1 of I/O expansion module (ICX207D)
10= Pb2 of I/O expansion module (ICX207D)
11= Pb3 of I/O expansion module I/O (ICX207D)
12= Pb4 of I/O expansion module (ICX207D)
13= Pb5 of I/O expansion module (ICX207D)
14= Pb6 of I/O expansion module (ICX207D)
15= Pb7 of I/O expansion module (ICX207D)
16= Pb8 of I/O expansion module (ICX207D)
17= Pb1 of electronic expansion valve 1 (IEV)
18= Pb2 of electronic expansion valve 1 (IEV)
19= Pb3 of electronic expansion valve 1 (IEV)
20= Pb4 of electronic expansion valve 1 (IEV)