Technical data

Ichill 200CX EVO rev 1.1 14/11/2013
Pag. 26 of 151
2. Push SET key: the label uSt1 (temperature probe ) or uSP1 (Pressure probe) is showed on bottom
display, the top display shows the the temperature or pressure value.
3. Use the UP or DOWN keys to select uSt1 auxiliary probe for circuit 1or uSt2 auxiliary probe for circuit 2.
4. To exit the Hour function push MENU key or wait the timeout.
How to display the tempaerature of the internal temperaure sensor of the remote terminal 1
or 2
Inside the funcion menu it is possible to see the ambient temperature detected by the NTC sensor
FUNCTION trEM to show the temperature of the remote panels
Identification label trEM.
trE1 value of the NTC probe of the remote #1
trE2 value of the NTC probe of the remote #2
Select with UP or DOWN the trEM function
Push SET the trE1 or trE2 label is shown on the bottom display, the top display shows the probe value.
Use the UP or DOWN arrow to change beteween trE1 or trE2 read-out.
To exit to the normal display read-out push MENU or wait the time – out time.
ATTENTION:
THE trEm function and the labels trE1 or trE2 appear only if the CF56 = =2 or 3 (remote panel 1
configuration) or if the parameter CF56 = 2 or 3 (remote panel 2 configuration).
11. ANALOG AND DIGITAL OUTPUT CONFIGURATION
11.1 ICHILL INPUT / OUTPUT CONFIGURATION
Analog input Pb1 - Pb2 – Pb5 – Pb6
0. Not enabled
1. Temperature probe PTC for compressor 1 discharge
2. Temperature probe PTC for compressor 2 discharge
3. Temperature probe PTC for compressor 3 discharge
4. Temperature probe PTC for compressor 4 discharge
5. Not used
6. Not used
7. Temperature probe PTC for solar panel
8. Temperature probe NTC for evaporator inlet
9. Temperature probe NTC for evaporator 1 outlet
10. Temperature probe NTC for evaporator 2 outlet
11. Temperature probe NTC for common evaporator outlet
12. Temperature probe NTC for common hot water condenser / recovery inlet
13. Temperature probe NTC for hot water of the condenser / recovery circuit 1 inlet
14. Temperature probe NTC for hot water of the condenser / recovery circuit 2 inlet
15. Temperature probe NTC for hot water of the condenser / recovery circuit 1 outlet
16. Temperature probe NTC for hot water of the condenser / recovery circuit 2 outlet
17. Temperature probe NTC for hot water of the condenser / recovery common outlet
18. Temperature probe NTC for free cooling water inlet circuit
19. Temperature probe NTC for dynamic setpoint external air / boiler / change over
20. Temperature probe NTC for combined defrost circuit 1
21. Temperature probe NTC for combined defrost circuit 2
22. Temperature probe NTC for auxiliary output 1
23. Temperature probe NTC for auxiliary output 2
24. Temperature probe NTC sanitary water 1
25. Temperature probe NTC sanitary water 1
26. Temperature probe NTC solar panel
27. Temperature probe NTC for condensing circuit 1
28. Temperature probe NTC for condensing circuit 2