User`s manual

• Obtain IP address via DHCP

Dynamic Host Configuration Protocol (DHCP) is a protocol that lets network administrators

centrally manage and automate the assignment of IP addresses on a network. DHCP is enabled by

default. Although a DHCP server is mostly used to set an IP address dynamically, it is also possible

to use it to set a static, known IP address for a particular MAC address.

• Use the following IP address

To use a static IP address for the NVR, check the radio button and then make the following

settings:

-. IP address:

Specify a unique IP address for the NVR.

-. Subnet mask:

Specify the mask for the subnet the NVR is located on.

6) Easy Install

You can activate or inactivate the Easy Install function in this window.

Change the admin password or use the default password (admin) of cameras to be detected. If you

don’t want to use easy install function, inactivate checkbox. Click the Next button to go to next page.

Note: Easy Install is inactivated in default. This make the NVR detects ONVIF based all of network

cameras and registers automatically.