Specifications

If problems occur, verify the installation of the camera with the instructions in this
manual and with other operating equipment.
Isolate the problem to the specific piece of equipment in the system and refer to
the equipment manual for further information.
PROBLEM
No video
1. Verify power is applied to all pieces of the
equipment in the system.
The camera LED should be ON.
2. Verity that the video cables are connected correctly.
3. Verity that the lens cap has been removed from the
lens and the iris of the lens is open.
6.2 PREVENTIVE MAINTENANCE
Preventive maintenance allows detection and correction of minor that
faults before they become serious and cause equipment failure.
Every three-month, perform the following maintenance.
1. Inspect all connection cables for deterioration or other damage.
2. Clean components with a clean damp cloth.
3. Verify that all the mounting hardware is secure.
6.1 TROUBLESHOOTING
Video but no
control
Power down the system for one minute then re-apply
power.
Dark Video
1. Adjust iris.
2. Check A/I connections.
- 89 -
AREA TO CHECK
6. Appendix
Frame rate
decrease
Change current value more lower resolution,
compression rate and frame rate.
A connection
is cut-off at
short intervals
Check network traffic and contact with network
administrator.