User's Guide

17 September 2021

NG Series Industrial Wireless Gateway User Guide

DIVIGRAPH

Doc No. 20DD1980

Revision 4

Update Gateway Software

You may on rare occasions need to update the NG Series Industrial Wireless Gateway software. Request

or download software updates from Divigraph technical support. You can update NG Series Industrial

Wireless Gateway software using the web-interface.

To update gateway firmware:

1. Use your web browser to navigate to the IP address of your NG Series Industrial Wireless Gateway

and login

2. Select “Maintenance” > “Software Upgrading”.

3. Click on the “Upload” file area to browse to and select the relevant gateway software file.

4. Wait for the upload to complete.

5. Click “Upgrade!”

6. Wait until the upgrade is completed.

Click on “Remove Files” to remove all uploaded software files before uploading new files.

Reset Gateway

The NG Series Industrial Wireless Gateway can be reset using the web-interface or using the power

connector if in a non-hazardous environment.

To reset the NG Series Gateway:

1. Navigate to “Maintenance”.

2. Select the “Restart” menu item.

3. Select “Soft Restart” or “Power Cycle”.

IPv4 Address Reset

To reset the NG Series Industrial Wireless Gateway IPv4 address using a magnet:

1. Place a magnet against the magnet icon located on the NG Series Industrial Wireless Gateway

until the status indicator starts flashing between green and amber.

2. Hold the magnet in position for approximately 5 seconds.

3. The status indicator should start flashing between amber and red indicating that the IPv4 address

has been reset to factory default (“192.168.1.1”).

4. Remove the magnet.