User's Guide

17 September 2021

NG Series Industrial Wireless Gateway User Guide

DIVIGRAPH

Doc No. 20DD1980

Revision 4

Outdoor Mounting

When installing outdoors, the gateway should be mounted upright, and the supplied connector guard

must be installed to protect against UV exposure as shown in Figure 4.

Figure 4: Connector guard installed for protection against UV exposure

Ground Connection

NG Series Industrial Wireless Gateways must be grounded using a suitable gauge grounding wire

connected to the grounding lug attachment point on the enclosure.

Surge Protection

The following information is intended as guidelines only and does not replace the need for surge

protection assessment and installation by a suitably qualified person according to local regulations.

General guidelines for surge arrester selection and application principles are given in standards such as:

• IEC 61643-12 - Low-voltage surge protective devices - Part 12: Surge protective devices connected to

low-voltage power systems - Selection and application principles.

• IEC 61643-22 - Low-Voltage Surge Protective Devices - Part 22: Surge Protective Devices Connected

To Telecommunications And Signalling Networks - Selection And Application Principles.

Refer to your site-specific requirements for selection and installation of surge arresters.