User's Guide

17 September 2021

NG Series Industrial Wireless Gateway User Guide

DIVIGRAPH

Doc No. 20DD1980

Revision 4

Configuration

Configure Gateways

We recommend performing basic configuration of NG Series Industrial Wireless Gateways in an indoors

equipment room or a similar environment before installation in the field.

This includes:

• Device web interface password (recommended; default username = “admin”; default password

= “Admin#1!”)

• TCP/IP IPv4 Address (default = “192.168.1.1”)

• ISA100 wireless Network ID (default = “5”)

• ISA100 wireless network Join Key (default = “00102030405060708090A0B0C0D0E0F0”)

• Device Tag (optional; default = “Gateway”)

To configure these settings:

• Use a PoE cable to connect the NG Series Industrial Wireless Gateway to a PoE adapter or

network switch – refer to the Plant Network Connection section for additional information.

• (Optional) Connect an external supply using the auxiliary power cable. For details see Power

Connection.

• Connect to the NG Series Industrial Wireless Gateway web interface using a host PC connected

to the PoE adapter or network switch.

• Set the host PC IPv4 address to a value within the NG Series Industrial Wireless Gateway default

IP address range and subnet.

• Use a web browser to access the gateway user interface - http://Device_TCP_IPv4_Address.

Keep connector protection caps in place to prevent exposure to contaminants for connections not used

during configuration or installation.

Set Password

For security purposes, we recommend you change the password for the NG Series Industrial Wireless

Gateway web interface.

To change the password:

• Select “Maintenance” > “Change Password”.