User's Guide

17 September 2021

NG Series Industrial Wireless Gateway User Guide

DIVIGRAPH

Doc No. 20DD1980

Revision 4

Network Requirements

The following requirements apply to the PC/laptop used to configure the Gateway.

Ethernet

• a Cat-5e (or higher) cable from any hub/switch capable of at least Ethernet 10/100 mbps

Compatible Web Browser applications:

• Chrome

• Mozilla Firefox®

Note: Microsoft® Internet Explorer® is not supported.

We recommend you use the most current version the compatible browser used.

These ports on the gateway need to be accessible from the host system through any network firewalls

that may be in place:

• Port 80 (HTTP)

• Port 502 (MODBUS)

• Port 4901(GCI)

All other ports are inaccessible on the gateway.

Setup Overview

To add a NG Series Industrial Wireless Gateway to your network:

1. Survey your installation location.

2. Decide where to install the gateways and identify mounting points.

3. Install and configure gateways.

4. Provision VP Series 2000 ISA100 field devices.

5. Test and verify your installation.

6. Monitor and maintain your network.

For more information regarding ISA100 network design, refer to the VP Series 2000 User Guide

(document EVR-VPXDOC-0036).