User's Guide

17 September 2021

NG Series Industrial Wireless Gateway User Guide

DIVIGRAPH

Doc No. 20DD1980

Revision 4

Installation and Configuration

This section describes how to connect to the NG Series Industrial Wireless Gateway (gateway) for the first

time and which settings should be configured before placing it on a live control network. It is important

to note that some gateways do not reside on a network. In these cases, it is still important to configure

the items outlined in this section.

Before the gateway is permanently mounted and connected to a live control network, it should be

configured with an IP address. This is done by forming a private network between the gateway and a

PC/laptop. The following items are needed to complete this section:

• NG Series Industrial Wireless Gateway

• Mounting hardware (plus adapters, if needed)

• Power supply (PoE injector or external PSU or both)

• Antenna

• Antenna cable (optional)

• Surge arrester(s) (required for outdoor or cabled antenna connections)

• RJ45 (8 pin) network cable (shielded Cat-5e or higher) with the supplied RJ45 gland

• A-coded M12 (4 pin) power cable or field connector (optional)

• VP Series 2000 field device(s)

Gateway Components

The device kit is composed of these parts:

• Gateway

o Enclosure base (anodised, powder-coated aluminium)

o Enclosure lid (anodised, powder-coated aluminium)

o RJ45 connector protection cap (required when RJ45 connector is not in use)

o M12 connector protection cap (required when M12 connector is not in use)

• RJ45 cable gland

• Mounting accessories

o Mounting flanges (for surface and pole mount)

o Mounting main bracket (for surface and pole mount)

o Mounting support bracket (for pole mount only)

o Mounting fasteners

• Self-amalgamating tape (for antenna installation)